Greetings,
We are running an Delta XP with Isodat 2.0 (latest patch).
The system should make a print out after each sample measured on the
Gasbench.
From time to time the print outs of a sequence are emty except for the
header text.

Open the template in the "Result Workshop" and save it again as .irw
file used to solve this problem in the past.
However, this time I did't find a way to bring the print out back to
work.
The sheets are always emty (except for the fixed header text) when
printed out during the measurement sequence.
When we later open the saved measurement (.cf files) in the Workspace or
the Aquisition module the print out works perfect.

I restarted the PC, switched to dual inlet mode and back to ConFlow,
installed the printer drivers, used different templates and created a
complete new print out template. No sucess. 

This is not a critical thing but is annoying. Any ideas?

Robert

-- 
Dr. Robert van Geldern
Section 3: Geochronology and Isotope Hydrology
Leibniz Institute for Applied Geosciences (GGA-Institute)

GEOZENTRUM HANNOVER
Stilleweg 2
30655 Hannover, Germany

Phone: +49-(0)511-643-2313
Fax: +49-(0)511-643-3665
mailto:[log in to unmask]