I removed and cleaned the ion source for our delta V advantage. I changed a 
new filament and I put back the source and everything looks fine on isodat 
screen. Values are…

HV= 3.01KV
Box= 0.72 mA
Trap= 0.77 mA
vacuum= 1.4e-006
Magnet (steps)= 11572 

When I select reference gas (CO2) on the conflo screen to do a jump 
calibration no CO2 gas is flowing into the system. I checked for a leak and NO 
leak, we have a half tank CO2 gas. It seems ions are not reaching the cups or 
ions are not generated. I checked the CO2 tank is open, conflo is open and 
SGE valve is open.

I am planning to remove the source again and see if the small opening in the 
side of the ion source chamber is somehow blocked or miss aligned (even 
though I checked every thing before I put it back) . Or when I pushed the 
source into the mass spectrometer possibly a wire may have been 
disconnected?. 

Any advice or suggestions before I remove the ion source again to check for 
any loose connection.

Thanks
Million