Hi everyone

Recently had a Costech 50 place zero-blank autosampler fitted to our Thermo MAT253 IRMS and wanted to get some advice from anyone running a similar setup.

Any issues, or tips on using it?

I’m mainly using it to analyse soils/plants for C&N

I envisage some dicking around with alignment and perhaps start and stop times of analysis on the EA, but was keen to hear if anyone has one and what method they use.

Thanks for reading.

Steve






[cid:image001.gif@01D81E5C.8F1C9830]
Steve Szarvas
Research Officer
Agriculture & Food | CSIRO
[log in to unmask]<mailto:[log in to unmask]>  |  + 61 (0) 448 887 769
Waite Road, Glen Osmond  SA  5064

CSIRO acknowledges the Traditional Owners of the land, sea and waters, of the area that we live and work on across Australia. We acknowledge their continuing connection to their culture and we pay our respects to their Elders past and present.

The information contained in this email may be confidential or privileged. Any unauthorised use or disclosure is prohibited. If you have received this email in error, please delete it immediately and notify the sender by return email. Thank you. To the extent permitted by law, CSIRO does not represent, warrant and/or guarantee that the integrity of this communication has been maintained or that the communication is free of errors, virus, interception or interference.

Please note, if I send you an email outside reasonable work hours I’m doing so because it’s convenient for me. In the spirit of encouraging work life balance I look forward to a response if appropriate at a time that suits you.

CSIRO Australia’s National Science Agency  |  csiro.au