I had a 252 that did this to me years ago. I ended up disconnecting the
heaters to avoid the problem. After a few years, other mysterious things
started to happen, and I finally tracked it down to a failing power supply
that was having trouble maintaining a DC voltage level. It's a different
instrument, of course....
[log in to unmask]
Alberta Innovates - Technology Futures*
Vancouver Island Technology Park
3 - 4476 Markham St.
Victoria, BC, Canada V8Z 7X8
*The Alberta Research Council, Alberta Ingenuity Fund, iCORE & nanoAlberta
are now part of Alberta Innovates - Technology Futures.
From: Stable Isotope Geochemistry [mailto:[log in to unmask]] On Behalf
Of Wurster, Chris
Sent: June 1, 2011 3:49 PM
To: [log in to unmask]
Subject: [ISOGEOCHEM] IsoDat Bug? Heaters turn on automatically
We have been having an interesting issue. In the middle of an EA-IRMS run
(in the middle of the night) all the heaters turn on (analyzer, inlet, inlet
I notice this in the morning because mass 46 is very high, while mass 44 and
45 are low compared to normal. this occurs on both the sample peaks and
reference pulses. After a slow magnet move to CO2 and a peak centre, the
expected voltages come back. It took me a while to note that the heaters
turned on as they are usually hidden, but this must be the underling issue
as the jump calibration is no longer valid.
I assumed this must be a strange bug in the software, and used version
handler to go back to when this problem didn't occur and it worked well for
a couple of weeks. Unfortunately, this morning... the heaters were on, and
the calibration was off.
Any help would be appreciated. We have a Costech EA, ConFlo IV, and Delta
VPlus, with IsoDat 3.0.
Chris Wurster, Ph.D.
Senior Research Associate
School of Earth and Environmental Sciences James Cook University Cairns 4870
Office Phone: +61-7-4042-1338
email: [log in to unmask]