I am having trouble getting a (new to me) DeltaVPlus talking to a 
(obviously, quite old) Conflo II.

The Conflo II was working as recently as three weeks ago on a DeltaPlus, 
and I had no trouble getting my old GC Combustion III talking to the new 
DeltaVPlus via the configurable plug and measure card. However, when I 
set the switches on that same P&M card for the Conflo II per the manual, 
I get no response at the Conflo II.

Is anyone else running this combination, and if so, can you tell me what 
I'm missing?

One thing that I have noticed is that on the Conflo II, the cable has 
two 10-pin connectors. Only one of those connectors was used on the 
DeltaPlus and the other was labeled "unused". Is it possible that I 
actually need two P&M cards even with the old Conflo II and what would 
the setting be on that second card ? (The Conflo IV has a cable with 
three 10-pin connectors, each to a different P&M card).

Any insight you might provide will be welcomed,

Thanks,
Carl


-- 
***********************************************************
***********************************************************
Mr. Carl G. Johnson
Research Specialist
Dept. of Marine Chemistry and Geochemistry
123 Fye Laboratory, MS#4
Woods Hole Oceanographic Institution
Woods Hole, MA 02543-1543
USA

Tel:  508-289-2304
Fax:  508-457-2164
[log in to unmask]
http://www.whoi.edu/website/organic-mass-spectrometry-facility/
***********************************************************
***********************************************************