I just cleaned out the source of my Delta V plus, reassembled it, and put it back in the machine... and it won't turn on. No high voltage, no box, no trap, nothing. I've pulled it out several times, glared at it a lot, stared at my pictures and notes, checked electrical connections, checked the magnet directions, checked the filament, and everything seems fine, except it's not working.
Can someone verify that I've got all the connections right:
1 = filament -
2 = 1st of 2 Y deflection plates (largest tip bent plates)
3 = 1st of 2 X deflection plates (bent plates closest to the source block)
4 = 1st of 2 "03"/extraction plates (middle of the stack on the box)
5 = 1st of 2 "04"/lens plates (top of the stack, closest to source block)
6 = 2nd of 2 "04"/lens plates
7 = 2nd of 2 "03"/extraction plates
8 = top of quad
9 = lamps/heaters
10 = filament +
11 = 2nd of 2 Y deflection plates
12 = trap
13 = box
2nd of 2 X deflection plates is connected to the whole source block
My vacuum is on the high side, but I was expecting that since the whole thing has been off for a while. I don't think that's what's keeping the source off. Vacuum was ~1.5E-7 this morning with all the inlet valves closed, but it's higher now since I've vented and pumped it down several times.
I'm feeling quite stupid right now and would really appreciate any suggestions!